Wavetek 39A Especificações descarregar pdf (Página 107)

User Manual 301/302

• 5M will connect 5 MHz low pass elliptic filter

• 2.5M will connect 2.5 MHz low pass elliptic filter

•

800K will connect 800 KHz low pass elliptic filter

OUTPut:FILTer:FREQuency?

Response

The 302 will return 150M, 10M, 5M, 2.5M, 800K depending on the type of filter presently connected to the

output.

OUTPut:FILTer:MODE NORMal | AUXiliary

Purpose

This command will route the filters to either the main outputs, or the auxiliary outputs.

• NORMal will route the filters to the main output connectors

• AUXiliary will route the filters to the auxiliary output connectors

OUTPut:FILTER:MODE?

Response

The 302 will return NORM if the filters are presently connected to the main outputs, or AUX if the filters are

connected to the auxiliary outputs.

OUTPut:SYNC OFF | ON | 0 | 1

Purpose

This command will turn the 302 SYNC output on and off.

• ON or 1 will set the SYNC output on

• OFF or 0 will set the SYNC output off

OUTPut:SYNC?

Response

The 302 will return 1 if the SYNC output is on, or 0 if the SYNC output is off.

OUTPut:SYNC:SOURce BIT | LCOMplete | PULSe

Purpose

This command will select 302 SYNC validator.

• BIT will set the SYNC to output a narrow pulse

• LCOMplete will set the SYNC to transition high at the beginning of the sequence and low a the end of

the sequence

• PULSe will enable pulse width control over the SYNC pulse

OUTPut:SYNC:SOURce?

Response

The 302 will return BIT, LCOM, or PULS depending on the present setting of the SYNC source.

SCPI Command Reference

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 136 137

Sem comentários

Wavetek 39A Especificações Página 107