Wavetek 3ST Especificações descarregar pdf (Página 44)

4-20

4.3.5 Sweep Transmitter

Forward Telemetry Frequency

Use the UP and DOWN arrow keys or the numeric keypad to enter

the telemetry frequency.

NOTE: For successful Stealth mode operation, the Rx telemetry

frequency must match the Tx telemetry frequency setting of

the Model 3ST Transmitter.

Caution: Do not place the telemetry signal too close to the diplex

filter cut-off frequency in that roll-off may attenuate the

telemetry signal to the degree that communication fails.

This same caution applies to placing the signal in the high

end roll-off region.

Forward Telemetry Level

This is the level of the carrier that the 3ST uses to transmit telem-

etry data. Use the edit box to set the Telemetry Level to an appro-

priate value. When adjusting the Telemetry Level, take into consid-

eration the following losses; system, summing network, test point,

and amplifier desired input.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 101 102

Sem comentários

Wavetek 3ST Especificações Página 44